»  Shopping

Tips to Maintain Water Well Pumps


By: Well Pump.   
Date Added : June 22, 2011 Views : 327


There was a time when water had to be pulled out from wells, and it was a matter of a lot of strength. However, these days the same thing can be done by simply setting up submersible water well pumps. These devices can actually be fitted to the lower part of wells to push water upwards with the help of a series of complicated mechanisms. Nonetheless, the entire procedure and mechanism behind the use of water well pumps and its maintenance need not be known to you. There are some simple steps that can help you in setting up well pumps and all you need to know is how well pumps work?

Jet pumps are the common types of water well pumps available today. These well pumps are usually mounted on the wall close to the source of water, such as a well. It helps in raising water from the ground with the help of a suction device. Now, the question here is how this suction is created? Well, suction is created with the help of a centrifugal pump or motor driven impellers. Water is sucked from well using narrow openings of the pumps or jet. As water leaves the jet, partial vacuum is created for sucking adequate water from the water well. Water will then go up through the series of water tubes and through plumbing system that has been created.

Jet well pumps are ideal for the shallow well pumps. As a matter of fact, shallow well pumps are often synonymously known as jet pumps. This is further used if the water table in your residing area is higher than usual. Unluckily, if you are residing in such an area where water table is too deep, you would require different types of well pumps known as submersible well pumps. Dissimilar to the jet pumps that functions by lifting water; these submersible well pumps push water up the surface.

Submersible pumps are cylindrical and long, more than half the portion of these well pumps are sealed motor pumps basically that are connected to external power sources and controlled by innumerable wires. The remaining half of the pump is made from impellers stacking one over another. These impellers are used for the up and down movement, thereby pushing water towards the surface layers. There are times when problems might crop up in case if the impellers are not properly aligned with the motor in use.

Well pumps troubleshooting are very important so that you can keep checking from time to time. You must understand whether or not the pump is use working out. In case if there is a leakage, it should be checked properly to determine the level of water in the well. In such cases, the well pump might have to be taken out to check whatever damage has occurred and it should be replaced only after inspecting the pipe properly. You might also have to check your entire plumbing system properly to understand if there are any major problems in the entire system so that the supply of water remains smooth and there are no future problems in the process.



DeepWell is the author of this article on Water Well pumps. Find more information on Submersible Well Pumps here.


eXTReMe Tracker